Fluke Power Supply FLK TI SBC3 User Manual

Safety Information  
Use the FLK-TI-SBC3 only as specified in this instruction sheet or other Fluke  
product-specific manual. See Table 1 for a list of symbols used on the FLK-TI-SBC3.  
Charging the Battery  
Before using the battery pack for the first time, charge the battery in the two-bay charging  
base for at least two and one-half hours. For complete charging instructions, see the “Ti32,  
TiR32 Thermal Imagers User Manual.”  
A Warning identifies hazardous conditions and actions that could cause bodily harm or  
FLK-TI-SBC3  
Charging Base/Power Supply with Adapters  
death.  
Specifications  
See Table 2 for the specifications.  
A Caution identifies conditions and actions that could damage the Imager or cause  
permanent loss of data.  
Table 2. Specifications  
WWarning  
Instruction Sheet  
10-15 Vdc 2 A or charge battery pack in Imager with included ac  
Battery Charging  
To avoid injury:  
adapter rated: 100-240 Vac 50/60 Hz, 15 V 2 A.  
The Fluke FLK-TI-SBC3 Charging Base/Power Supply with Adapters charges the Fluke  
FLK-TI-SBP3 Smart Battery Pack for Thermal Imagers. The FLK-TI-SBC3 consists of a  
charging base, power supply, and power outlet adapters.  
Do not disassemble or short circuit the battery pack.  
Do not expose the battery pack to temperatures above 50 °C (122 °F).  
Do not incinerate or mutilate the battery pack.  
Use only ac adapters approved by Fluke for the product to charge the battery or  
power the product.  
Status  
Charging LED  
no battery detected  
charged  
Power LED  
off  
no dc power input  
Charging / Power LED  
solid green  
dc power present  
blinking green  
blinking red  
charging  
na  
na  
Table 1. Symbols  
fault  
Dimensions  
159.5 mm x 68.9 mm x 51.3 mm (6.28 in x 2.71 in x 2.02 in)  
-10 °C to 70 °C (-14 °F to 158 °F)  
Symbol  
P
Description  
Operating Temperature  
Storage Temperature  
Humidity Range  
Conforms to requirements of European Union and European Free Trade Association.  
Imager connected to battery charger.  
Y
TTER  
-20 °C to 80 °C (-4 °F to 176 °F) without batteries  
10 % to 95 % non-condensing  
3
BA  
T
R
SMA  
CHARGER  
"
Ti SBC3  
WER  
PO  
Conforms to relevant Australian standards.  
;
Conforms to relevant Canadian and US standards  
Important information. See manual.  
)
W
Do not dispose of this product as unsorted municipal waste. Go to Fluke’s website for  
recycling information.  
~
PN 3481481 August 2009  
© 2009 Fluke Corporation. All rights reserved. Printed in USA.  
All product names are trademarks of their respective companies. Specifications are subject to change without notice.  
 

Echo Brush Cutter PAS 2100 TYPE 1E User Manual
Eizo Computer Monitor FDU2602W User Manual
Electro Voice Microphone 671B User Manual
Excell Precision Scale DIGITAL HIGH PRECISION WEIGHING SCALES User Manual
Focal Car Speaker 165 KRXS User Manual
Frigidaire Double Oven FFGF3047L S User Manual
Frigidaire Double Oven FGB24T3E User Manual
Furuno Stereo Receiver DSC 60 User Manual
GE Kitchen Grill 106642 User Manual
GE Microwave Oven 164D2966P147 User Manual