Extron electronic Switch WPB 109 User Manual

WPB 109 Wallplate • Installation Guide  
AUDIO  
The Extron WPB 109 wallplate is a single gang  
pass-through wallplate with audio, VGA, and HDMI  
connectors and 10-inch pigtails. It can be installed in  
the supplied single gang mud ring or a junction box.  
COMPUTER  
HDMI  
Install the wallplate directly into the wall using the  
supplied mud ring or a UL-approved 1-gang junction  
box (not supplied). Follow the steps in the “Installation”  
section.  
WPB 109  
Front  
Side  
Planning - Check the Proposed Installation Location  
Before starting the installation it is important that you do the following:  
WARNING: Failure to check these items may result in property damage, personal injury,  
or both.  
Ensure there are no utility cables or pipes at the intended location that might be damaged  
or cause injury when you are installing the device.  
c
c
Check that the installation meets the local and state regulatory requirements, including  
building, electrical, and safety codes, and UL and ADA accessibility requirements.  
During installation ensure the space behind the device is sufficient for the bend radius of the  
pigtail. The recommended minimum bend radius is 2.4 inches.  
Installation  
1. Using the supplied mud ring or a junction box (not included) as a guide, mark and cut out  
the appropriate material within the marked area.  
2. Either:  
Locking Arms  
z
z
Insert the mud ring into the opening, rotate the  
locking arms, and secure it with the supplied screws  
(as shown at right), or  
Wall Mounting  
Bracket  
Insert the junction box and secure it with nails or  
screws.  
O
AUDI  
3. Run the cables (video, audio, and HDMI) from the output  
or input device locations (as applicable), behind the wall,  
and to the WPB location, then thread the cables through  
the mud ring or junction box.  
COMPUT
I
HDM  
WPB 109  
Extron  
WPB 109  
4. Video — Insert the HDMI and VGA cable connector into  
the appropriate connector on the pigtail.  
NOTE: If using a DVI display with the WPB 109, connect a HDMIM-DVIDF adapter (part  
number 26-617-01) and a separate audio cable.  
5. Audio Secure the output audio cable into the 3-pole captive screw connector. Wire as  
described in “Cable Preparation for Audio Connections” on page 2.  
NOTE: This may be easier to do before attaching the device to the mud ring.  
6. Mount the cabled device into either the mud ring or the junction box.  
CONTINUED ON SIDE 2  
1
 

Echo Trimmer SRM 3800 TYPE1 E User Manual
EFJohnson Two Way Radio 7243 LTR Net Portable UHF User Manual
Exmark Lawn Mower Ultra Vac User Manual
Extron electronic Scale DSC 301 HD User Manual
Extron electronic Stereo Amplifier IR 102 User Manual
FieldServer Computer Drive FS 8700 40 User Manual
Franke Consumer Products Plumbing Product FF 1600 User Manual
FujiFilm Film Camera AF3 007E User Manual
Gateway Network Router NB304N User Manual
Gemini Musical Instrument PS 03 User Manual