Extron electronic Speaker S1 26W User Manual

Cutout Template  
188 mm x 275 mm  
(7.4” x 10.8”)  
Paint Guard  
SI 26W  
In-Wall Speaker  
User’s Guide  
1
4
Determine the speaker location.  
Insert the speaker into the wall opening.  
Leave at least 1” clearance from the edge of the speaker  
to the studs in all directions. Hold or tape template in location,  
make sure template is level. Trace along the inside of the template.  
Loosen the six screws on the front baffle (counter-  
clockwise) 1/2 turn. Then tighten the screws (clockwise)  
until the dog legs clamp the speaker to the wall.  
At least 1” from the stud.  
Trace template  
2
5
Carefully cut a hole along the inside of the traced line.  
Level speaker, position each wall clamp outward, and tighten  
each screw until snug.  
Install dust shield to protect the speaker during ongoing  
construction.  
Cut material  
CAUTION  
Do not over-tighten screws.  
3
Attach the speaker wires to the 2-pole captive screw plug.  
Use red for the positive (+) wire and black for the negative (-)  
wire. Insert the 2-pole captive screw plug into the 2-pole  
connector on back of the speaker.  
Dust Shield  
6
Remove the dust shield,  
install the speaker grill.  
eaker  
SI 26W  
Sp  
e
a
l
l
a
s
n
c
In-W  
m
Impedh  
O
8
0
X 00/0  
X
X
X
X
E
X
X
X
X
X
X
X
X
N
S
SA  
U
eered in  
Engin  
Specifications:  
Application diagram:  
Acoustic & Electrical  
Speaker type.................................. 2-way in-wall speaker  
Frequency range........................... 40 Hz to 20 kHz, -10 dB, half space  
Power capacity.............................. 60 W continuous program,  
30 W continuous pink noise  
T
PU  
T
OU  
T
F
I
ED  
E
L
IF  
PL  
T
M
A
IGH  
R
12V  
IR  
Rx  
B
Tx  
C
/M  
C/IR  
L
A
2
3
2
P
RS-  
AM  
PRE  
Nominal sensitivity......................  
Nominal impedance .................... 8 ohms  
Crossover frequency................... 2.5 kHz  
Woofer........................................... 6.5" (165 mm) polypropylene cone with  
moisture resistant coating  
89 dB, 1 W, 1 m, half space  
S
T
PU  
2
T
NEOU  
IN  
IO  
D
1
I
L
U
L
A
SI 26W  
Two-way In-wall  
Speaker  
Projector  
L
IX  
M
X/  
ST  
U
U
J
A
D
B
A
R
-42d  
O
T
B
24d  
R
+
IO  
IO  
D
U
A
S
EL  
R
T
EV  
PU  
L
O
IN  
E
M
O
IN  
N
L
D
U
A
5
6
R
B
S
G
T
PU  
T
OU  
O
IT  
N
O
M
R
S
T
E
D
PU  
IN  
VI  
Extron  
MLS 304SA  
MediaLink Switcher  
z
50-60H  
2
V
100-240  
1
Tweeter.......................................... 0.75" (19 mm) titanium dome  
X.  
A
M
1.0A  
General  
Temperature/humidity...............  
Storage: -40 to +158 °F (-40 to +70 °C) /  
10% to 90%, noncondensing  
Laptop  
w/ Audio  
Operating: +32 to +122 °F (0 to +50 °C) /  
10% to 90%, noncondensing  
Warranty ....................................... 5 years parts and labor  
PC  
VCR  
68-1101-01 Rev A  
08 07  
NOTE: All nominal levels are at 10%.  
NOTE: Specifications are subject to change without notice.  
Print at 100%. - Do Not “Fit to Paper”.  
 

Dyson Vacuum Cleaner DC 14 User Manual
Earlex Paint Sprayer HV1900 User Manual
Fagor America Electric Pressure Cooker SZ2L00002 User Manual
Festool Sander RO 150 E User Manual
FoodSaver Food Saver V2490BC User Manual
Frigidaire Range 316135932 User Manual
Garmin GPS Receiver 010 00990 01 User Manual
GarrettCom Switch Magnum 6KQ User Manual
GE Answering Machine 20801800 User Manual
GE Washer G142 User Manual