Eizo Computer Monitor FP 2701W User Manual

Note  
Please be careful not to scratch the LCD panel or the cabinet with the panel protector during installation. Also please do  
not remove the panel protector often. It may scratch or result in damage to the LCD panel.  
The panel protector has a non-glare treatment side and a glossy side. Use preferable side.  
When using LCD monitor with optional panel protector, it is preferable to avoid using downwards. In this condition, the  
panel protector might become bend or slip out from the monitor.  
Installation  
Before installation, please remove dust and stains from the LCD panel.  
1.  
2.  
3.  
(2)  
(1)  
Stopper  
Lever  
1. Set the panel protector into the grooves of the panel frame; the lower first (1), then the upper (2).  
2. With the enclosed tool (Lever) set the tabs of the panel protector into the side grooves (6 tabs).  
Put the lever on the tabs of the panel protector and move it toward the LCD panel to install. Position the protector into the  
LCD panel tightly without leaving an opening.  
For the recommendation, please use the stoppers to prevent the panel protector from bending or  
slipping out from the monitor.  
3. Before installation the stoppers, please remove dust and stains from the cabinet of the monitor.  
Follow these steps to install the stoppers.  
1. Remove the protection paper from the stoppers.  
2. Position the stoppers to the tab of the panel protector and install them on the cabinet of the monitor.  
Removing  
Release the stoppers from the cabinet. Put the lever on the tabs of panel protector and move it  
toward the cabinet to remove.  
Cleaning  
Note  
Please be sure to keep the panel protector immobilized while cleaning it. Otherwise it may scratch the surface of the LCD  
panel. To hold the panel protector by hand, use a soft cloth to avoid dust or finger prints.  
Never use thinner, benzene, alcohol (ethanol, methanol, or isopropyl alcohol), abrasive cleaners, or other strong solvents,  
as these may cause damage to the cabinet or panel.  
The panel surface can be cleaned with a soft cloth such as cotton or lens paper.  
If necessary stubborn stains can be removed by moistening part of the cloth with water to enhance its  
cleaning power.  
Tips  
It is recommended to use EIZO cleaning kit “ScreenCleaner” (option) to clean the panel.  
Specification  
Surface treatment  
Coating strength  
Reflectivity  
Non-glare side: non glare hard coating / Glossy side: hard coating  
2H  
Less than 6.8 %  
Light transmission  
Dimension/ Weight  
Accessories  
More than 90 %  
585.1 mm (W) × 367.2 mm (H) × 1.0 mm (D) / approx. 265 g  
Lever (for Panel Protector), Stoppers x 5, User’s Manual  
Copyright© 2007 EIZO NANAO CORPORATION All rights reserved.  
00N0L396A1  
(U.M-FP2701W)  
 

Eaton Electrical Calculator MN05401014E User Manual
Eureka Vacuum Cleaner 1040 Series User Manual
Exergen Thermometer 2000C User Manual
Fellowes Paper Shredder P 57Cs User Manual
Fisher Price Baby Gym 74120 User Manual
FujiFilm Digital Camera 16124456 User Manual
Fujitsu Flat Panel Television PDS4213W H User Manual
Fujitsu Telephone F9600 F9600c User Manual
Furuno Answering Machine ARP 17 User Manual
Gefen Switch EXT HDMI13 242 User Manual