Gefen Network Router EXT HDMI13 145 User Manual

1:5 Splitter For  
HDMI 1.3  
Model #EXT-HDMI1.3-145  
USER MANUAL  
 
TABLE OF CONTENTS  
1. Introduction  
2. Features  
3. Panel Descriptions  
4. Connecting and Operating the 1:5 Splitter for HDMI 1.3  
5. Specications  
6. Warranty  
 
INTRODUCTION  
The Gefen 1:5 Splitter for HDMI 1.3 allows set-top boxes, DVD players, Blu-  
ray players and other HDTV devices with HDMI outputs to be connected to  
up to ve HDTV displays (or more if multiple splitters are utilized in place of  
HDTV displays  
How It Works  
The 1:5 Splitter for HDMI 1.3 is a distribution hub that sends the same HDMI  
signals to up to ve HDTV digital displays. You simply connect your HDMI  
video source to the 1:5 HDMI 1.3 Splitters HDMI input jack, then connect  
your HDMI-compatible displays to each of the HDMI outputs. Power-cycle  
all equipment and you should see beautiful, sharp HDMI video on all of your  
HDMI displays.  
OPERATION NOTES  
READ THESE NOTES BEFORE INSTALLING OR  
OPERATING THE 1:5 SPLITTER FOR HDMI 1.3  
Display information from the display connected to HDMI output port 1 is sent  
back to the source. Therefore, all other displays connected to the 1:5 Splitter  
for HDMI 1.3 must be capable of accepting the timings and resolutions of the  
display that is connected to HDMI output port 1. It is recommended that the  
display with the lowest native resolution be connected to HDMI output port 1.  
This is to ensure that a compatible video signal will be able to be displayed  
on all connected monitors.  
HDMI/HDCP compliant  
Compatible with all HDMI and DVI* displays  
*When used with a HDMI to DVI adapter  
1
 
FEATURES  
Features  
Lip-Sync Pass Through  
225 MHz (up to 12 bit YUV 444 supported @ 1080p)  
Deep Color Supported (XV Color Supported)  
Color Space Conversion Supported  
Dolby Tru-HD & DTS Master Supported  
CEC Pass Through  
Includes:  
(1) 1:5 Splitter for HDMI 1.3  
(1) 6 ft HDMI cable (m-m)  
(1) 24V DC Power Supply  
(1) Set of Rack Ears  
(1) User’s Manual  
2
 
PANEL DESCRIPTIONS  
3
 
CONNECTING AND OPERATING THE 1:5 SPLITTER FOR HDMI 1.3  
How to Connect the 1:5 Splitter for HDMI 1.3 to your devices  
1. Connect the supplied cable from the HDTV HDMI source into the 1:5  
Splitter for HDMI 1.3 input.  
2. Connect the cables from your displays (monitor or projector) into the  
HDMI outs of the 1:5 Splitter for HDMI 1.3.  
3. Plug the 24VDC power supply into the 1:5 Splitter for HDMI 1.3.  
NOTE: Display information from the display connected to HDMI output port 1 is  
sent back to the source. Therefore, all other displays connected to the 1:5 Splitter  
for HDMI 1.3 must be capable of accepting the timings and resolutions of the display  
that is connected to HDMI output port 1. It is recommended that the display with the  
lowest native resolution be connected to HDMI output port 1. This is to ensure that a  
compatible video signal will be able to be displayed on all connected monitors. There is  
a generic 1080i EDID programmed into the 1:5 Splitter for HDMI 1.3 that can be used  
instread. Please see below for the activation process.  
EDID SWITCH  
The HDMI 1:5 has an EDID Switch which will determine if you are going to  
use the EDID from the display attached to output 1 or use an onboard EDID.  
If you want to use the EDID from the display attached to output 1, make  
sure the switch is selected to "EXT".  
If you want to use the onboard EDID, make sure the switch is selected to  
"INT" which will give you a generic EDID of 1080i.  
4
 
SPECIFICATIONS  
Video Amplier Bandwidth.................................................................225 MHz  
Input Video Signal........................................................................1.2 volts p-p  
Input DDC Signal...................................................................5 volts p-p (TTL)  
Single Link Range.............................................................1080p/1920 x 1200  
HDMI Connector..............................................................type A 19 pin female  
Power Supply.......................................................................................24V DC  
Power Consumption.................................................................60 watts (max)  
Dimensions...................................................................17”W x 1.75”H x 5.5”D  
Rackmountable.........................................................................1U rack space  
Shipping Weight......................................................................................5 lbs.  
5
 

Continental Refrigerator Refrigerator SW72 12C FB User Manual
Cornelius Ice Maker 2400 R404A User Manual
Craftsman Lawn Mower Accessory 358792421 User Manual
Cuisinart Griddle CGR 4C User Manual
Curtis Freezer FRF452 User Manual
Dixon Lawn Mower 1950 2300 Series User Manual
DuPont Authentication Insect Control Equipment H 65190 User Manual
Electro Voice Portable Speaker S1522ER User Manual
Garland Oven PS 36RB 26 User Manual
GE Monogram Oven ZSC2000FWW BB User Manual