Dynex Computer Drive DX PHD35 User Manual

Quick Setup Guide  
DX-PHD35 3.5" PATA Hard Drive Disk Enclosure  
2 Pull out the plastic end cap with the circuit board.  
Package contents  
Connecting the enclosure to your computer  
USB 2.0 3.5" PATA hard drive enclosure  
Note: Make sure you have already installed a hard drive into the enclosure before  
USB 2.0 cable A-B  
AC power adapter  
Utility CD with User Guide and Roxio BackOnTrack software  
Accessories:  
Screwdriver  
Screws (4)  
you connect the enclosure to your computer.  
USB 2.0 A type connector  
USB 2.0 B type connector  
User Guide  
Quick Setup Guide  
1 Plug the AC power adapter into the 12V DC jack, then plug it into an AC power  
outlet.  
2 Plug the USB B type connector into the enclosure, then plug the A type  
connector into one of the available USB 2.0 ports on your computer.  
3 Press the power button to turn on the enclosure. The operating system  
automatically detects and sets up the new drive. The power LED turns on when  
the enclosure/hard drive turns on.  
System requirements  
Computer with an available USB 2.0 port  
3.5" PATA hard drive  
Windows 7, Windows Vista, and Windows XP operating system.  
MAC OS X version 10.4 or higher operating system.  
For highest performance and reliability, install the latest updates and service  
3 Connect the drive to the 40-pin data connector and to the power connector on  
the enclosure circuit board, then secure the drive to the rails with the four  
screws (provided).  
4 If the drive is correctly detected, a new drive letter is assigned.  
For PCs, the new drive letter appears in My Computer.  
For Macintosh computers, the new drive letter appears on your desktop.  
pack (SP). For Windows, go to the Start menu, then select Windows Update.  
Note for Windows users: If you do not see an additional drive in your system,  
you must format the new drive. See the instructions below.  
Note for Macintosh users: If you do not see an additional drive in your system,  
select Disk Utilities from the Utilities folder, then select the external enclosure  
and format the drive to meet your requirements.  
Features  
Power LED  
Activity LED  
Power switch  
5 If the drive is new and is not formatted, follow the steps below to format the  
drive. Otherwise, continue to “Installing the backup software.  
Backup button  
USB 2.0 B type  
12V DC  
4 Place the hard drive with the plastic cap back into the aluminum housing and  
secure it with the two screws you previously removed.  
Installing your hard drive in the enclosure  
1 Remove two screws on the left side of panel.  
Screw  
Screw  
 

Coleman Tent 2000001585 User Manual
Conair Styling Iron CS64 User Manual
Craftsman Trimmer 31679187 User Manual
Crown Audio Stereo Amplifier Pulse 4X300 User Manual
Curtis Camcorder VR285 User Manual
Elation Professional Baby Accessories MH W User Manual
EVGA Computer Hardware 131 K8 NF44 User Manual
Franke Consumer Products Ventilation Hood FKU 368 TC I User Manual
Frigidaire Dishwasher Dishcare User Manual
GE Monogram Dishwasher ZBD5600 User Manual