Crate Amplifiers Musical Instrument Amplifier FXT30 User Manual

FXT30  
FXT30  
Guitar Amplifier with  
Digital Signal Processing  
User’s Guide  
 
FXT30Guitar Amp with Digital Signal Processing  
The Front Panel:  
1
2
3
4
5
6
7
8
9
10  
11  
12  
13  
1: INPUT: Use this 1/4jack to connect your guitar to  
the amplifier by means of a shielded instrument cable.  
12: HEADPHONES: Use this jack to connect head-  
phones to the amplifier. The internal speaker is dis-  
connected when headphones are used.  
SOLO CHANNEL: A high gain channel giving you  
CAUTION: To avoid possible damage to your  
hearing, do not use headphones for extended  
periods of time at extremely loud levels.  
sounds from a slight edge to serious overdrive.  
2: GAIN: Use this control to adjust the amount of dis-  
tortion for the Solo channel.  
13: POWER: Use this switch to turn the amplifier on  
(top of the switch depressed) and off (bottom of the  
switch depressed). The switch illuminates when the  
amplifier is turned on.  
3: SHAPE: Use this control to adjust the tone of the  
Solo channel.  
4: LEVEL: Use this control to adjust the output level  
of the Solo channel.  
The Rear Panel (not shown):  
5: SOLO/CLEAN: Use this switch to select the Solo  
or Clean channel. With the switch in the out position,  
the Clean channel is selected. When the switch is  
depressed, the Solo channel is selected.  
14: EXTENSION SPEAKER: Use this jack to connect  
the amplifier to an external speaker. The internal speak-  
er is disconnected when this jack is used. The imped-  
ance of the external speaker must be 4 ohms or greater.  
CLEAN CHANNEL: A normal gain channel designed  
to give you crystal clear sounds to medium distortion.  
WARNING: Do not attempt to use headphones in  
the Speaker jack! Permanent hearing damage  
could result!  
6: VOL: Use this control to adjust the output level of  
the Clean channel.  
15: FOOTSWITCH: Use this jack to connect the 1/4”  
stereo plug on the cable of a two-button footswitch  
(such as the Crate CFP2). This allows you to remote-  
ly switch between the Clean and Solo channels and  
turn the DSP effects on and off.  
7: LOW: Use this control to adjust the low frequency  
level of the clean channel.  
8: MID: Use this control to adjust the midrange fre-  
quency level of the clean channel.  
16: POWER CORD: The grounded power cord should  
only be plugged into a grounded power outlet that meets  
all applicable electrical codes and is compatible with the  
voltage, power, and frequency requirements stated on  
the rear panel. Do not attempt to defeat the safety  
ground connection.  
9: HIGH: Use this control to adjust the high frequen-  
cy level of the clean channel.  
10: DSP LEVEL: Use this control to adjust the level of  
the selected digital effect. The DSP effects can be  
turned on and off by using a footswitch (#16, rear  
panel).  
11: DSP MODE: Use this control to select one of the  
16 built-in digital effects. The numbers around the  
control correspond to the digital effects as listed in the  
chart below.  
The Digital Effects:  
1 - Small Room Reverb  
2 - Medium Room Reverb  
3 - Large Room Reverb  
4 - Concert Hall Reverb  
9 - Flange with Reverb and Delay  
10 - Slow Tremolo Chorus With Reverb  
11 - Chorus with Reverb and Delay  
12 - Rotating Speaker  
5 - Short Slapback with Small Room Reverb  
6 - Medium Delay with Plate Reverb  
7 - Long Delay with Large Room Reverb  
8 - Slow Deep Flange with Reverb  
13 - Octave Divider  
14 - Touch Wah  
15 - Inverse Wah  
16 - Doubler  
 
FXT30Guitar Amp with Digital Signal Processing  
FXT30 TECHNICAL SPECIFICATIONS:  
Output Power Rating  
Gain  
>30W RMS @ 5% THD, 4, 120 VAC  
Solo Ch  
98dB +/-6dB @ 1kHz  
42dB +/-6dB @ 1kHz  
Clean Ch  
Maximum Input Signal Accepted  
Tone Controls  
6 volts peak-to-peak min. @ 1kHz  
Low  
Mid  
20dB range @ 80Hz  
12dB range @ 900Hz  
18dB range @ 10kHz  
High  
Speaker Size and Rating  
Power Requirements  
10Crate Custom Design 4 ohm  
120 VAC, 60Hz, 50VA  
100/115VAC, 50/60Hz, 50VA  
230VAC, 50/60Hz, 50VA  
Size and Weight  
15-1/4H x 17W x 10D, 20 lbs.  
The FXT30 is covered with a durable Tolex material: wipe it clean with a lint-free cloth.  
Never spray cleaning agents onto the cabinet. Avoid abrasive cleansers which would damage the finish.  
Crate continually develops new products, as well as improves existing ones. For this reason, the specifications  
and information in this manual are subject to change without notice.  
©2003 SLM Electronics, a division of St. Louis Music, Inc • 1400 Ferguson Avenue • St. Louis, MO 63133  
47-743-02 • 030504  
 

Coleman Tent 2000007832 User Manual
CompuSTAR Two Way Radio 2WFMRS User Manual
Desa Stove FSVYD18P User Manual
DigiTech Guitar CR 7 User Manual
Dukane Projector 8784 User Manual
Dymo Printer Electronic Date Time Stamper User Manual
Electro Voice Portable Speaker PIM 251 User Manual
Euro Pro Carpet Cleaner SC926H User Manual
Everpure Water System EV9275 60 User Manual
Fundex Games Games 3830 00 User Manual