Connerton Co Griddle CEG SERIES User Manual

Installation,  
Operation &  
Maintenance  
Instructions  
Fine Cooking Equipment For Over 70 Years  
CEG SERIES THERMOSTATIC GRIDDLES  
For Your Safety  
Warning!  
Do NOT store or use gasoline or  
other flammable vapors and  
liquids in the vicinity of this, or  
any other equipment.  
Improper installation, adjustment, alteration, service or  
maintenance can cause property damage, injury or  
death. Read the installation, operation and maintenance  
instructions thoroughly before installing or servicing  
this equipment.  
To Purchaser  
After installation of your griddle, immediately contact your local gas supplier to obtain  
information in the event the user of your equipment smells gas. This information must be  
posted in a prominent location.  
To User  
RETAIN THIS MANUAL FOR FUTURE USE  
Upon receipt of this griddle, inspect it thoroughly for any damage which may have occurred  
during shipment. If damage is observed, contact the delivery agency immediately.  
1. Preparation For Installation: Safe and satisfactory operation of the griddle depends, to a great  
extent, upon it’s proper installation. It should be installed in accordance with the National Fuel  
Gas Code Z223.1, these instructions, and applicable State and Local Codes.  
Installation must be made by a licensed plumber.  
A gas pressure regulator is supplied with your griddle. The regulator must be installed before  
connecting griddle to gas supply line. Please note: air vent can plug with grease, thereby shutting  
gas supply off. Install regulator in a drip-free area.  
The griddle and it’s individual shutoff valve must be disconnected from the gas supply piping  
system during any pressure testing of that system at test pressures in excess of 1/2 psig (3.45  
kPa).  
The griddle must be isolated from the gas supply piping system by closing it’s individual manual  
shutoff valve during any pressure testing of the gas supply piping system at test pressures  
equal to or less than 1/2 psig (3.45 kPa).  
2. Clearances And Ventilation: This griddle is designed for installation in non-combustible locations  
only with 4” clearance from sides and 6” clearance from back.  
The Connerton Company  
1131 E. Wakeham Avenue, Santa Ana, CA 92705-4145  
Telephone: (714) 547-9218 Fax: (714) 547-1969  
 
1
8
14  
7
9
6
2
11  
10  
12  
13  
5
3
4
CEG THERMOSTATICALLY-CONTROLLED GRIDDLES  
1. 05-476-xx  
2. 05-400-xx  
3. 05-426-xx  
4. 05-450-00  
5. 05-301-xx  
6. 05-200-01  
05-200-02  
Griddle Plate  
Body  
Front Panel  
Grease Pan  
Gas Manifold  
Orifice Hood - Natural  
Orifice Hood - Propane  
Air Shutter  
9. 05-350-00  
10. 00-225-00  
11. 05-251-01  
05-251-02  
12. 00-525-00  
13. 05-550-00  
14. 00-275-01  
00-275-02  
Pilot w/tubing  
Pilot Valve  
Thermostatic Control (right)  
Thermostatic Control (left)  
Thermostatic Knob Bezel  
Thermostatic Control Knob  
Regulator - Natural  
7. 05-675-00  
8. 05-150-00  
Regulator - Propane  
Burner  
*** For part numbers ending in xx, specify model size (ie; 05-400-48 for a CEG-48)  
 
TROUBLESHOOTING GUIDE  
Condition  
Probable Cause  
Solution  
Small/no burner flame  
Regulator failure  
Unplug regulator vent hole or  
replace regulator.  
Thermostatic calibration  
By-pass setting  
Re-calibrate thermostat.  
Adjust by-pass setting.  
Unplug hole or replace orifice.  
Unplug burner port(s).  
Plugged orifice hood  
Plugged burner port  
Small/no pilot flame  
Yellow burner flame  
Pilot valve setting  
Plugged pilot tip  
Adjust flame height.  
Unplug pilot ports.  
Improper air shutter setting  
Increase air shutter setting until  
flame is blue.  
Enlarged orifice hood  
Replace w/correct orifice.  
Flame lifts off burner  
Improper air shutter setting  
Decrease air shutter setting  
until flame sits on burner.  
Plugged orifice hood  
Improper level setting  
Unplug orifice hole or replace orifice.  
Adjust level w/feet or shims.  
Too hot/cold  
Improper control setting  
Adjust control setting or replace  
control.  
Improper level setting  
Adjust level w/feet or shims.  
Thermostatic calibration  
Re-calibrate thermostat and by-pass.  
LIMITED WARRANTY  
The Connerton Company warrants to the original user for a period of one year from date of  
installation, not to exceed 18 months from date of shipment by Connerton, that the equipment  
manufactured is free from defects in material or workmanship.  
Our obligation under this warranty shall be limited to furnishing without charge any part of said  
product which, upon examination by The Connerton Company shall prove to be defective. Parts wear  
is not considered a defect. The Connerton Company will not be responsible for labor or  
transportation charges incidental to the replacement of same.  
The Connerton Company assumes no responsibility for failure of the equipment to operate properly  
due to improper installation or operation. This warranty applies to all equipment that has been  
unaltered, properly installed and maintained in accordance with national and local codes and in  
accordance with the installation and operating instructions included with this equipment.  
This warranty does not extend to normal maintenance items, including but not limited to,  
thermostatic calibrations, air and gas adjustments and adjustments to pilot flames. Proper  
installation, adjustments, calibration and initial checkout is the responsibility of the dealer, the  
owner-user or installer and not that of The Connerton Company.  
Please fill out and refer to the following when contacting the factory:  
Model # CEG  
-T  
Serial#  
Gas Type:  
Purchase Date:  
 

Coleman Outdoor Fireplace 5065 700 User Manual
Compaq Personal Computer 243850 002 User Manual
Conair Styling Iron CD202R User Manual
Craftsman Pressure Washer 919672241 User Manual
Electro Voice Microphone 205C User Manual
Electro Voice Speaker System EVID 121P User Manual
Fisher Price Motorized Toy Car R9543 User Manual
Fisher Price Riding Toy J4390 User Manual
Frigidaire Washer MLXG42RE User Manual
Gigabyte Network Card GA K8NMF 9 User Manual