Sony Portable Multimedia Player NWZ F804 User Manual

Parts and Controls  
Initial Settings  
How to Install the Supplied Software  
What You Can Do with Your “WALKMAN”  
(Including Help guide)  
To enjoy music/videos/photos  
1 Use the supplied USB cable to connect your  
Walkman to a running computer and charge the  
Walkman.  
1 Connect your Walkman to a running computer  
Quick Start Guide  
using the supplied USB cable. Plug in the USB  
cable with  
facing upward, making sure the  
How to Install the Supplied Software  
How to Use Your “WALKMAN”  
Your Walkman turns on.  
connection is secure.  
Note  
If a large battery symbol is displayed while you  
You can transfer music from CDs and transfer videos and photos to your Walkman using  
a computer.  
are charging your Walkman, the remaining  
charge is still too low for your Walkman to  
operate. The Walkman will start automatically  
after being charged for about 10 minutes.  
To enjoy FM radio  
You can listen to FM radio using the supplied headphones.  
2 If the USB connected screen appears, tap the  
(Back) button to quit the screen, and then  
proceed to the initial settings.  
NWZ-F804/F805/F806  
To enjoy Internet  
©2012 Sony Corporation Printed in Malaysia  
(Menu) button  
(Home) button  
(Back) button  
The language selection screen* appears.  
Hint  
Wi-Fi  
You must accept the terms of the End User License Agreement when you use  
your Walkman for the first time. To read them again later, tap the (Menu)  
button - [System settings] - [ About device] - [Legal information] - [Sony  
EULA].  
If [USB connected] appears on the screen, tap [Turn on USB storage] to connect  
*
Depending on where you purchased your Walkman, the language selection  
screen may not appear.  
your Walkman.  
If the following screen does not appear, swipe the status bar on the top of the  
screen and tap [Turn on USB storage] on the notification panel.  
3 Select the desired language to be used to display  
Headphone jack  
WM-PORT jack  
the End User License Agreement.  
Status bar  
About the manuals  
In addition to this Quick Start Guide, this model is accompanied by a Help  
guide (HTML document) that gives detailed operating instructions.  
To view on your “WALKMAN” screen:  
See “How to Use the Help guide on Your “WALKMAN.”  
To view on a computer screen:  
You can browse the Internet and download applications by connecting to a Wi-Fi  
network.  
Connect the USB cable (supplied), or other accessories that support WM-PORT  
(not supplied).  
4 Make sure that you understand the terms of the  
license agreement then tap [Agree].  
The initial setup screen appears.  
Hint  
Speaker  
For details about this function or usage, refer to the Help guide (HTML document).  
Strap hole  
See “How to Install the Supplied Software (Including Help guide).”  
5 Tap .  
Built-in microphone  
Built-in antenna  
Wi-Fi, Bluetooth, and GPS antennas are built-in.  
Screen (touch screen)  
Touch (tap) icons, items, control buttons, etc., on the screen to operate your  
Walkman.  
4-432-452-11(1)  
VOL (Volume) +/– button  
(Double-u Dot) button  
You can access your Walkman from the computer.  
2 Select your Walkman on the computer.  
This is used to directly display the W.control.  
Contents  
Click [Start] - [Computer] or [My Computer] - [WALKMAN].  
RESET button  
Please check the items in the package.  
WALKMAN” (1)  
Headphones (1)  
Earbuds (Size S, L) (1)  
At purchase, M size earbuds are installed.  
USB cable (1)  
Attachment (1)  
Use when connecting your Walkman to a peripheral device, such as a cradle  
(not supplied).  
Quick Start Guide (this manual)  
Software  
The software is stored in the built-in flash memory of your Walkman, and  
includes the following items. For details on how to install, see “How to Install  
the Supplied Software (Including Help guide).”  
Media Go  
WALKMAN Guide  
Help guide, etc.  
3 Double-click [Setup.exe].  
Press the RESET button with a small pin, etc., to reset your Walkman.  
The install wizard appears.  
(Power) button  
Hold down: Turns the power on/off.  
Press: Turns the screen on/off.  
Hint  
6 Select the desired language.  
7 Tap to begin using your Walkman.  
When you execute [Setup.exe], the [Setup.exe] file stored in the [WALKMAN]  
folder of your Walkman is copied to your computer for backup, and the  
WALKMAN Guide and Media Go are installed to your computer.  
If you changed the type of USB connection to a setting other than MSC mode,  
change mode back to MSC mode again by tapping [Connected as USB Storage] on  
the notification panel.  
About volume operation (Only for  
countries/areas complying with European  
Directives)  
If [Setup.exe] does not start, copy the [Setup.exe] file to your desktop, then  
double-click it.  
An alarm (beep)* and warning [Check the volume level] are meant to protect your  
ears when you raise the volume setting beyond a specific level for the first time. You  
can cancel the alarm and warning by tapping [OK] button on the alert dialog.  
4 Follow the on-screen instructions.  
After the install wizard finishes, the  
(WALKMAN Guide) icon  
appears on the desktop of your computer. You can view the Help  
* The alarm (beep) does not sound when connecting a Bluetooth audio device.  
guide by double-clicking the  
clicking on the Help guide.  
(WALKMAN Guide) icon and  
Note  
You can turn up the volume beyond the specific level after canceling the alarm and  
warning.  
5 Start Media Go.  
After the initial warning, the alarm and warning repeat for every 20 cumulative hours  
that the volume is set beyond the specific level; when this happens, the volume is  
changed to the initial setting automatically.  
About Windows Operating System  
You can transfer content stored on your computer to your Walkman.  
For details on transferring music, etc., refer to the Help guide.  
Make sure that the OS is Windows XP (Service Pack 3 or later), Windows Vista*  
(Service Pack 2 or later) or Windows 7* (Service Pack 1 or later).  
If the volume is set beyond the specific level and you turn off your Walkman, the  
volume returns to the specific level automatically.  
Hint  
*
[Compatibility mode] for Windows XP is not supported.  
You can start the WALKMAN Guide and Media Go from the [Start] menu (displayed by  
clicking [Start]).  
8 Set the Wi-Fi connection, Google account and  
date/time, etc., following the instructions shown  
on the screen.  
You can install the supplied software on another computer through the following  
procedure even if you delete the [Setup.exe] file by formatting the built-in flash memory  
of your Walkman. Copy the [Setup.exe] file and the [Install] folder from the [Backup]  
folder of your computer to the Walkman. Then, connect the Walkman to another  
computer on which you want to install the software and follow the above procedure  
from step 2.  
Hint  
Wi-Fi connection and Google account can also be set afterwards.  
The [Backup] folder can be found at  
C:\Program Files\Sony\WALKMAN Guide\NWZ-F800\Backup  
([Program Files(x86)] may be displayed depending on the computer OS.)  
 

Sharp Fax Machine FO 11 User Manual
Sharp PDAs Smartphones EL 6930 User Manual
Shiro Telephone SC3128 User Manual
Sony Cordless Telephone SPP A1070 User Manual
Sony Flat Panel Television VPCL224FD B User Manual
Sony Laptop AVIO Notebook User Manual
Sony Stereo System STRDH520 User Manual
Spalding Fitness Equipment M800034 User Manual
Tally Genicom Printer Matrix Printer User Manual
Tamron Camera Lens AF001C700 User Manual