Sony Home Theater System SRS BTD70 User Manual

Listening to music from a paired  
Listening to Music by  
Wireless Connection with  
a Bluetooth Device  
Bluetooth device  
Rear of the system  
1 Turn on the system.  
AUDIO IN jack  
DC IN 5.2V jack  
2 Make sure the (Bluetooth) indicator (blue) on  
the system flashes.  
You can enjoy music with the system wirelessly by using your  
device’s Bluetooth function.  
If the (Bluetooth) indicator (blue) is off, press the INPUT  
For details on how to operate your device, refer to the operating  
instructions supplied with the device.  
button so that the (Bluetooth) indicator (blue) flashes.  
3 Set the Bluetooth function of the Bluetooth  
Check the following before operating the system.  
Wireless Speaker System  
device to on.  
Both the system and the device are placed within 1 m (3 ft) of  
each other.  
The system is connected to a power source, or batteries are  
installed into the system.  
The operating instructions supplied with the device are kept  
at hand.  
Battery compartment (rear of the system)  
Operating Instructions  
4 Select “SRS-BTD70shown in the display of the  
Bluetooth device.  
The Bluetooth connection is completed and the (Bluetooth)  
indicator (blue) on the system stays on.  
Note  
Pairing with a Bluetooth device  
This step may not be necessary for some devices.  
and listening to music  
5 Start playback on the Bluetooth device, then  
POWER switch  
Bluetooth devices need to be “pairedwith each other  
beforehand.  
adjust the volume.  
Set the volume of the Bluetooth device to a moderate level,  
INPUT/ PAIRING button  
and press the VOLUME –/+ buttons on the system.  
1 Turn on the system.  
4-430-852-11(1)  
©2012 Sony Corporation Printed in Malaysia  
Tips  
VOLUME −/+ button  
2 Set the Bluetooth function of the Bluetooth  
You can adjust the volume of the system via a Bluetooth device  
device to on.  
supporting AVRCP (Audio/Video Remote Control Profile) VOLUME  
UP/DOWN. For details, refer to the operating instructions supplied  
with the device.  
POWER indicator (green)  
For details, refer to the operating instructions supplied with  
the device.  
(Bluetooth) indicator (blue)  
SRS-BTD70  
The volume of the system may not be controllable, depending on  
the device.  
3 Press and hold the PAIRING button on the  
system until the (Bluetooth) indicator (blue)  
begins to flash quickly.  
Note  
Function of Parts  
Turning the System on/off  
1 Connect the supplied AC adaptor.  
More than one device can be paired with the system, but sound  
will be heard from just one of those devices.  
English  
Wireless Speaker System  
Precautions  
POWER switch  
Before operating the system, please read this guide thoroughly  
and retain it for future reference.  
Notes when using with a mobile phone  
Turns the system on/off.  
To finish listening  
Do any of the following operations.  
You cannot use this system to talk over the telephone, even if  
a Bluetooth connection between this system and a mobile  
phone is made.  
INPUT/ PAIRING button  
Press to use the Bluetooth connection or pair with a Bluetooth  
Set the Bluetooth function of the Bluetooth device to off. For  
details, refer to the operating instructions supplied with the  
device.  
WARNING  
device.  
For details on operation of your mobile phone when receiving  
a telephone call while transmitting the sound using the  
Bluetooth connection, refer to the operating instructions  
supplied with the mobile phone.  
Press also to listen to the sound from the device connected to  
the AUDIO IN jack.  
To reduce the risk of fire or electric shock, do not expose this  
apparatus to rain or moisture.  
Turn off the Bluetooth device.  
Turn off the system.  
VOLUME −/+ button  
Adjusts the volume. The POWER indicator (green) flashes three  
times when the volume is set to minimum or maximum.  
To reduce the risk of electrical shock, do not open the cabinet.  
Refer servicing to qualified personnel only.  
To delete all pairing information from  
the system  
On safety  
The nameplate indicating Sony trademark, model number and  
electrical rating is located on the bottom exterior of this system.  
(Bluetooth) indicator (blue)  
To reduce the risk of fire, do not cover the ventilation opening of  
the apparatus with newspapers, tablecloths, curtains, etc. Do not  
place the naked flame sources such as lighted candles on the  
apparatus.  
Hold the VOLUME − button and press the INPUT/ PAIRING  
Lights up or flashes depending on the communication status.  
For details, see the following section, “Indications of the  
Bluetooth function.”  
Before operating the system, be sure that the operating  
voltage of the system is identical with that of your local power  
supply.  
button for more than 5 seconds while the system is turned on.  
The POWER indicator (green) lights up, and the (Bluetooth)  
indicator (blue) flashes quickly. The system is reset to its default  
and all pairing information is deleted.  
POWER indicator (green)  
Lights up when the system is turned on. Flashes during battery  
operation if battery power is low.  
To reduce the risk of fire or electric shock, do not expose this  
apparatus to dripping or splashing, and do not place objects  
filled with liquids, such as vases, on the apparatus.  
Where purchased  
Operating voltage  
2 Turn the POWER switch to ON.  
The indicator flashes quickly.  
All countries/regions  
100 V – 240 V AC, 50/60 Hz  
The POWER indicator (green) lights up.  
AUDIO IN jack  
Connects to the headphone jack of a portable audio device,  
computer, etc., using the supplied connecting cord.  
4 Perform the pairing procedure on the Bluetooth  
Do not install the appliance in a confined space, such as a  
bookcase or built-in cabinet.  
device to detect the system.  
Listening to Music by  
Wired Connection with a  
Portable Audio Device,  
etc.  
Notes on the AC adaptor  
If “SRS-BTD70does not appear on the device’s display,  
repeat from step 2.  
When connecting or disconnecting the AC adaptor, turn off  
the system beforehand. Otherwise, it may cause malfunction.  
Use only the supplied AC adaptor. To avoid damaging the  
system, do not use any other AC adaptor.  
DC IN 5.2V jack  
Connects the supplied AC adaptor.  
As the main plug of the AC adaptor is used to disconnect the AC  
adaptor from the mains, connect the system to an easily  
accessible AC outlet. Should you notice an abnormality in the  
system, disconnect the main plug from AC outlet immediately.  
Note  
Battery compartment  
Insert three LR6 (size AA) batteries (not supplied).  
Some devices cannot display a list of detected devices.  
5 Select “SRS-BTD70shown in the display of the  
The system is not disconnected from the mains as long as it is  
connected to the AC outlet, even if the system itself has been  
turned off.  
Bluetooth device.  
Indications of the Bluetooth function  
Status  
1 Connect the device to the system.  
Polarity of the plug  
(Bluetooth) indicator (blue)  
6 If Passcode* input is required on the display of  
Plug the AC adaptor into a nearby wall outlet (mains). In the  
case of a problem, unplug it from the wall outlet (mains)  
immediately.  
Do not install the AC adaptor in a confined space, such as a  
bookcase or built-in cabinet.  
To reduce the risk of fire or electric shock, do not expose the  
AC adaptor to dripping or splashing, and do not place objects  
filled with liquids, such as vases, on the AC adaptor.  
On Copyrights and Licenses  
the Bluetooth device, input “0000.”  
Pairing with a device  
Searching for a device  
Connected to a device  
AUDIO IN mode  
Flashes quickly  
Flashes  
The Bluetooth® word mark and logos are owned by the Bluetooth  
SIG, Inc. and any use of such marks by Sony Corporation is under  
license.  
The Bluetooth connection is completed and the (Bluetooth)  
indicator (blue) on the system stays on.  
Lights up  
Off  
* Passcode may be called “Passkey,“PIN code,“PIN number,”  
or “Password.”  
Other trademarks and trade names are those of their respective  
owners.  
The indicator lights up.  
7 Start playback on the Bluetooth device, then  
CAUTION  
adjust the volume.  
You are cautioned that any changes or modifications not  
expressly approved in this manual could void your authority to  
operate this equipment.  
To use with LR6 (size AA) batteries (not  
supplied)  
On placement  
Set the volume of the Bluetooth device to a moderate level,  
and press the VOLUME –/+ buttons on the system.  
Connecting cord (supplied)  
Do not set the speaker in an inclined position.  
Do not leave the system in a location near heat sources, or in a  
place subject to direct sunlight, excessive dust, moisture, rain  
or mechanical shock.  
1
Press and slide the cover.  
Tip  
To pair with other Bluetooth devices, repeat steps 2 to 6 for each  
Do not expose the battery to excessive heat such as direct  
sunlight, fire or the like.  
device.  
Notes  
On operation  
Pairing mode of the system is cancelled after about 5 minutes, and  
Do not insert any small objects, etc., into the jacks or  
the (Bluetooth) indicator (blue) turns off. If the pairing mode is  
cancelled while performing this procedure, start over from step 3.  
Passcode of the system is fixed as “0000.The system cannot be  
paired with a Bluetooth device whose Passcode is not “0000.”  
Once Bluetooth devices are paired, there is no need to pair those  
devices again. However, in the following cases, you will need to  
perform the pairing procedure again.  
ventilation hole on the rear of the system. The system may  
short out or malfunction.  
2 Turn on the system.  
2
Install three LR6 (size AA) batteries (not supplied), then close  
the cover.  
On cleaning  
3 Make sure the (Bluetooth) indicator (blue) on  
Do not use alcohol, benzine, or thinner to clean the cabinet.  
the system is off.  
If the (Bluetooth) indicator (blue) is on or flashing, press  
Pairing information is deleted after repair, etc.  
The system is paired with 9 or more devices.  
Others  
the INPUT button to turn it off.  
If you have any questions or problems concerning this system  
that are not covered in this manual, please consult your  
nearest Sony dealer.  
The system can be paired with up to 8 Bluetooth devices. If a new  
device is paired after 8 devices have been paired, the device  
whose latest connection time is the oldest among the 8 paired  
devices is replaced by the new one.  
4 Start playback on the connected device, then  
adjust the volume.  
3
Turn the POWER switch to ON.  
Set the volume of the connected device to a moderate level,  
and press the VOLUME –/+ buttons on the system.  
Tip  
If the AC adaptor is used with the system, the power source  
switches to power from the wall outlet (mains) automatically, even  
if batteries are installed.  
 

Snapper Chipper SG3000 User Manual
Sony All in One Printer UP DR80MD User Manual
Sony Graphics Tablet SGP521 User Manual
Sony Stereo Receiver 3 289 204 423 User Manual
Sound Storm Laboratories Computer Monitor SSV104FL User Manual
Star Manufacturing Waffle Iron SWCBE User Manual
Star Trac Home Gym Shoulder Press User Manual
Sterling Plumbing Indoor Furnishings C7111FSS User Manual
Sylvania TV VCR Combo SSC091 User Manual
Tanaka Trimmer THT 2530 2540 User Manual