Sonance Freezer AVC100R User Manual

INSTALLATION INSTRUCTIONS  
AVC1 0 0 R/ AVC1 0 0 SL/ AVCDWP 2  
A VC AUDIO DISTRIBUTION SYSTEM  
PN.33-1324 7.00  
Patent Pending  
AVC100SL  
INTRODUCTION  
The AVC100SL is a slider-controlled Amplified Volume Control. It is  
identical in operation and specifications to the AVC100R, except a  
continuously-variable slider is provided in place of a rotary knob.  
Thank you for purchasing an AmplifiedVolume Control (AVC) product  
from Sonance.When properly installed in a system,these products will  
provide you with years of entertainment pleasure. To obtain the full  
potential of your new purchase, please read all instructions before  
starting the installation.If you do not have the necessary skills to install  
a unit yourself, please contact your authorized Sonance dealer for  
installation options. The AVC100R, AVC100SL and AVCDWP2 are UL  
Listed and meet CE requirements EN 60065, EN 55013, EN 50082.  
Recommended Power Supply  
Any UL Listed regulated switching power supply, input rated  
90-240Vac, output rated 24Vdc, 2.5A with 2.1mm mini-plug and  
markedClass 2”(see specifications on page 4).  
AVC SYSTEM INTERCONNECTION  
AVC PRODUCTS  
The AVC system can be connected in any of the following ways:  
The AVC system is a new, modular approach to amplifying and  
distributing audio for residential and commercial applications.  
Depending on installation requirements, your AVC system will be  
made up of the following products, as shown in Figure 1:  
Daisy-chain (series) wiring  
Home-run (parallel) wiring  
Anycombination of daisy-chain and home-run wiring  
Study the examples in Figures 2 through 3 (on the next two pages) to  
learn how to interconnect systems using these wiring schemes.  
NOTE: Do not connect a signal power cable to the “SPEAKERoutput  
connector on any AVC100R/SL. Doing so may damage the unit.  
System Expansion  
There is virtually no limit on how many AVC100R/SLs are  
interconnected in a system, as long as the following conditions  
are met:  
AVCDWP2  
AVC100R  
AVC100SL  
1. One (1) recommended power supply +24Vdc powers up to six (6)  
AVC100R/SLs. If additional AVC100R/SLs are required in the  
installation,connect one (1) recommended power supply for each  
additional group of six (6)AVC100R/SLs (see detail in Figure 2 on  
page 2).  
Figure 1 - AVC system products  
2. One (1) AVCDWP2 Driver Wall Plate can drive a system of up to  
100AVC100R/SLs.Beyond that,you will need to divide the system  
so it is driven from two or more AVCDWP2s.  
WARNING: TO PREVENT THE RISK OF FIRE OR  
ELECTRIC SHOCK, DO NOT EXPOSE THIS  
APPLIANCE TO RAIN OR MOISTURE.  
Adjusting System Levels  
CAUTION: RISK OF ELECTRIC SHOCK - DO NOT OPEN  
The AVCDWP2 Driver Wall Plate includes two trim pots for individual  
adjustment of the systems left and right audio channels (see detail in  
Figure 2 on page 2). At the factory, both trim pots have been set for  
+10 dB gain on all three sets of outputs. However, the trim pots  
provide an adjustment range from OFF (full CCW) to +19 dB  
(full CW).  
AVC100R  
The AVC100R is a rotary-knob Amplified Volume Control. It provides  
the equivalent of 30 watts of amplification at the head end of  
conventional audio system run over 100 feet of wire.The knob action  
continuously varies the volume of the internal amplifier from zero to  
maximum volume. The unit provides 4-conductor quick-disconnect  
terminals for input, a looping output, and connection to local  
speakers. The AVC100R fits into a standard single-gang plaster ring.  
Mono Operation  
Each AVC100R or AVC100SL is preset at the factory for stereo  
operation. However, this can be easily changed to mono operation by  
moving an internal jumper (see detail in Figure 3 on page 3). In this  
mode, the blended mono signals are routed to both left and  
right outputs.  
AVCDWP2  
Fuse Replacement  
Each AVC100R/SL or AVCDWP2 is protected by an internal fuse (see  
detail in Figure 3 on page 3). For safety concerns, only replace a fuse  
with the same type and rating.  
The DWP2 is a Driver Wall Plate for audio distribution of a connected  
stereo source and routing of AVC power from a connected  
recommended power supply.Theunit fits into a standard single-gang  
plaster ring. Three parallel four conductor outputs with quick  
disconnect terminals are provided. One DWP2 may be used with up  
to 100 AVC100R/SLs via standard 16/4 or 14/4 wire. The DWP2 also  
provides installer-adjustable gain controls for setting the maximum  
system volume level (see the detail in Figure 2 on the next page).  
1
 
Right Speaker  
Right Speaker  
Left Speaker  
Left Speaker  
AVC100R/SL MONO OPERATION  
AVC100R (side)  
Remove (2) Screws  
Fuse  
AVC100R (side)  
AVCDWP2 (side)  
Move  
Jumper  
m
o
n
o
Remove (2) Screws  
AVC100R (side)  
See detail in Fig. 2  
NOTE:Do not connect to AVC100R/SL "SPEAKER" connector.  
Power Supply  
To AC Outlet  
24Vdc, 2.5A  
DC Power  
Right Speaker  
Left Speaker  
AVC100R (side)  
AVC100R (side)  
AVC100R (side)  
AVC100R (side)  
Right Speaker  
Right Speaker  
Right Speaker  
Left Speaker  
Left Speaker  
Left Speaker  
Figure 3 – Example of an AVC system with daisy-chain (series) and home-run (parallel) wiring.  
3
 
SPECIFICATIONS  
AVC100R/AVC100SL  
DESCRIPTION:  
TECHNICAL ASSISTANCE  
If you any have questions about the operation or installation of your Sonance AVC  
system products, please call our Technical Assistance Department on any business  
day at:  
Local,full-bandwidth, 2-channel distribution ampli-  
fier with rotary (AVC100R) or slider (AVC100SL) vol-  
ume control; fits standard single-gang plaster ring.  
Continuously-variable from 0 to 7.5 watts (rms) per  
channel into a nominal 8-ohm load.  
(800) 582-0772 or (949) 492-7777; between 9 A.M.and5P.M.,PST  
POWER OUTPUT:  
OBTAINING SERVICE  
If your product should need repair or service,contact your authorized Sonance dealer  
for help.  
FREQUENCY RESPONSE: 20 Hz ~ 20 kHz  
INPUT CONNECTIONS:  
LOOP CONNECTIONS:  
(4) Quick-Disconnects; Left, Right, GND, +24 Vdc.  
(4) Quick-Disconnects; Left, Right, GND, +24 Vdc.  
SPEAKER CONNECTIONS: (4) Quick-Disconnects; Left +, Left –, Right +, and  
Right –. Load is 4 ohms per channel, minimum.  
STEREO/MONO MODES: Selectablevia internal jumper.  
WARRANTY COVERAGE (USA ONLY)  
Sonance offers you a one (1) year limited warranty on each of your AVC products.You  
must observe the following conditions in order to receive this protection:  
FUSE:  
Internal; type AGC, 1 A, 250 V.  
1. Retain your bill of sale or legible facsimile (photocopy).If your unit(s) should ever  
require service, the bill of sale shall act as your proof of ownership and give the  
effective date of your warranty.  
DIMENSIONS:  
4-3⁄ 32" H X 1-5⁄ 8" W X 4-1/4" D (overall)  
2-3⁄ 4" H X 1-5⁄ 8" W X 3-3⁄ 8" D (in-wall)  
AVCDWP2  
DESCRIPTION:  
2. Read the below warranty thoroughly.Sonance offers you certain rights outlined in  
your warranty and requires specific conditions to be met.You may also have other  
rights which vary from state to state.  
Stereo driver amplifier connects to hi-fi stereo  
source and up to 100 AVC100R/SLs; fits standard  
single-gang plaster ring.  
(2) color-coded, stereo RCA jacks; 50 kinput  
impedance.  
INPUT CONNECTIONS:  
One-Year Limited Warranty  
OUTPUT CONNECTIONS: (3) sets of (4) Quick-Disconnects: Left, Right, GND,  
and +24 Vdc.  
FREQUENCY RESPONSE: 20 Hz ~ 20 kHz  
POWER CONNECTIONS: Female, 2.1 mm, mini-plug connects to  
recommended power supply.  
Sonancewarrantstotheoriginalpurchaserfortheperiodof one(1)year,eachAVCunit  
to be free from defects in material and workmanship provided each unit is operated in  
accordancewiththeprintedinstructionsincludedwiththeunit.One(1)yearbeginson  
the date of purchase shown on the bill of sale (receipt).  
For this warranty to be effective,the bill of sale must also show from whom each unit  
was purchased and the purchase price. In the event proof of purchase cannot be  
established as stated in the previous sentence(s),warranty shall commence on the date  
eachunitwasshippedfromthefactory,providedtheserialnumberoneachunithasnot  
been altered or in any way tampered with.This warranty shall apply exclusively to the  
original purchaser and shall not apply to purchasers who purchased units solely for  
industrial or commercial purposes.  
GAIN CONTROL:  
FUSE:  
(2) L/R trim pots provide +19 dB adjustment range.  
Internal; type AGC, 0.5 A, 250 V.  
4-3⁄ 32" H X 1-5⁄ 8" W X 3-5/8" D (overall)  
2-3⁄ 4" H X 1-5⁄ 8" W X 3-3/8" D (in-wall)  
DIMENSIONS:  
Minimum Recommended Power Supply Specifications  
Description:  
+24 Vdc, 2.5 A, voltage-regulated switching power  
supply with short-circuit protection; for use with up  
to six (6) AVC100R/SLs.  
During the warranty period, Sonance agrees to repair or, at its discretion,  
replace at no charge components that prove to be defective,provided a unit is  
returned in accordance with the shipping instructions found within the  
product installation instructions/owners manual. This warranty does not  
apply if a unit has been damaged by accident or misuse, or as a result of  
service or modification by unauthorized personnel.  
CURRENT DRAW:  
AC CONNECTIONS:  
1.5 A maximum at 50 watt rating  
110 Vac male IEC plug with supplied power cable  
connects to standard 110 Vac outlet. Multi-voltage  
input auto-switches from 110~240 Vac (50~ 60 Hz)  
for use in Europe or Australia.  
DC CONNECTIONS:  
6' attached cable with male, 2.1 mm, mini-plug for  
connection to AVCDWP2.  
UL Listed “Class 2”  
This warranty is limited to Sonance product(s) registered herein and specifically  
excludes any damage to loudspeakers and other allied or associated equipment which  
may result for any reason from use with this product.  
Marked:  
The warranty set forth above is in lieu of all other warranties, express or implied, of  
merchantability,fitness for a particular purpose or otherwise.Inno event shall Sonance  
be liable for incidental or consequential damages or have any liability with respect to  
defects other than as specifically set forth above.  
Declaration of Conformity  
We, Sonance  
212 Avenida Fabricante  
San Clemente, CA 92672  
U.S.A.  
declare in own responsibility, that the products described in this owner’s  
manual is in compliance with technical standards:  
EN 60065 : 1994  
EN 55013 : 1990  
EN 50082 : 1992  
Sonance  
San Clemente, CA  
U.S.A.  
7/00  
212 Avenida Fabricante • San Clemente, CA 92672-7531, USA (800)582-7777 or(949)492-7777 • FAX: (949)361-5151 • Technical Support: (800) 582-0772  
 

Sharp Stereo System XL UH240H BK User Manual
Sherwood Stereo Receiver RX 4109 User Manual
Shindaiwa Trimmer T242 User Manual
Sony Portable CD Player CDX S2200 User Manual
Sony Speaker System DSR 20 20P User Manual
Spectrum Brands Computer Hardware MC31XX User Manual
Stoelting Freezer SC118 User Manual
Sunpentown Intl Refrigerator RF 322W User Manual
Sylvania Digital Photo Frame SDPF733 User Manual
Sylvania TV VCR Combo SRC2213W User Manual