Soleus Air Water Dispenser Aqua Sub MW 59 User Manual

Aqua Sub  
Easy-Load Water Cooler  
MW-59 Owner’s Manual  
PLEASE SAVE THESE INSTRUCTIONS  
WARNING: READ THIS OWNER’S MANUAL CAREFULLY BEFORE USE.  
 
IMPORTANT SAFETY INSTRUCTIONS  
When using electrical appliances, basic safety precautions should be followed to  
reduce the risk of fire, electric shock, and injury to persons or property. Read all  
instructions before using any appliance.  
1. Do not let hot water touch bare skin. Keep combustible material such as furniture,  
bedding, pillows, clothes, and/or papers away from the back of the unit.  
2. Do not operate this, or any other appliance, with a damaged power cord. No other  
appliance should be plugged into the same outlet. Be sure that the plug is fully  
inserted into the outlet.  
3. Do not run the power cord over carpeting or other heat insulators. Do not cover the  
cord. Keep cord away from high traffic areas, and do not submerge in water.  
4. We do not recommend the use of extension cord as it may overheat and cause a risk  
of fire.  
5. Exercise caution and use reasonable supervision when the appliance is used by or  
near children.  
6. Do not use your water dispenser outdoors. Place the water dispenser away from  
direct sunlight and make sure that there is at least 4 inches (10cm) of space between  
the back of your unit and wall. Keep a minimum of 2 inches (5cm) on each side of  
your unit free.  
7. Do not use this product to dispense anything other than water.  
8. To avoid a hazard due to instability of the appliance, it must be placed on even and  
flat surface.  
9. If the supply cord is damaged, the manufacturer or its service agent or a similarly  
qualified person must replace it in order to avoid a hazard.  
10. This water cooler must be positioned so that the plug is accessible.  
11. Disconnect the plug from the outlet when not in use.  
12. Remove power plug or disconnect from the main power source before servicing the  
appliance.  
 
PRODUCT DIAGRAM  
 
UNPACKING THE WATER COOLER  
1. Cut and remove the straps from the box. DO NOT turn the box upside down, or lay it on  
its side. The bottom of the box is separate from the top section. Lift straight up on the top  
box section to remove the top box section. Remove the Styrofoam packaging and plastic  
bag. Lift the water cooler off the bottom of the box. Wipe it clean if necessary.  
2. Place the machine on a hard, flat surface. Make certain the unit is level. The unit should  
not be close to direct sunlight or other source of heat.  
3. It is best to place the water cooler in an area with good air circulation. Make sure there is  
at least 4 inches (10cm) of space between the back of your water cooler and the wall.  
Keep a minimum distance of 2 inches (5cm) on each side of your water cooler.  
WARNING: The drain cap on the back of the unit may become loose during shipping. Fasten  
the drain cap tightly before you start to operate the unit. If the drain cap is loose, the unit may  
leak and cause floor damage.  
PREPARING THE WATER COOLER FOR USE  
The Aqua Sub is different from a traditional water cooler. The water bottle does not need to be  
placed upside down on the top of the unit. The water bottle is placed in the lower cabinet of the  
unit, and then a pump draws the water up to the dispenser.  
Figure 1  
Figure 2  
 
1. Make sure the water dispenser is not plugged into  
an electrical outlet.  
2. Open the door of the lower cabinet and pull the tray  
out from the cabinet.  
3. Place a full water bottle on the tray. Remove the  
plastic cover over the mouth of the water bottle.  
4. Put the hose inside the water bottle and place the  
water bottle cap firmly over the mouth of the water  
bottle. (Figure 1)  
5. Push the tray inside the cabinet of the water cooler.  
Attach the hose to the water cooler by pressing in  
on the knob of the hose cap and sliding over the  
connector at the top of the cabinet. Push up firmly  
to assure the connection is tight. (Figure 2)  
6. Close the lower cabinet door.  
7. Plug the water cooler into a grounded power outlet  
and turn on the power switch located on the back.  
8. The unit will start to operate, but you should wait at  
least half an hour before using the water cooler.  
NOTE: If there is not a secure connection between the hose cap and the connector on the  
water cooler, the water pump will operate but the water cooler will not dispense water.  
Make sure the hose is connected to the water cooler correctly.  
NOTE: Please wait until the water pump stops running before using the unit. If the water tank is  
not full, no water will dispense from the tepid water faucet and the hot water faucet.  
NOTE: The second time the water bottle is changed after the light on the front panel is on,  
switch RESET to OFF for 3 seconds.  
OPERATION  
After the water bottle has been connected to the water cooler, the unit is ready for use. Turn the  
power switch on the back of the unit to ON. The water cooler will start running. First the unit  
will pump the water from the water bottle into the cooling and heating tanks, and then the unit’s  
compressor and heater will start to operate. The first time the water cooler is used, you will have  
to wait at least half an hour for hot and cold water.  
When the indicator light on the front panel is on, there is no water left in the water bottle. The  
water bottle will need to be replaced. Replace the water bottle, and then press the RESET button  
located on the backside of the unit. The water cooler will work again and the indicator light will  
be off.  
 
CLEANING AND MAINTAINENCE  
To avoid accidents, turn off and unplug the water cooler from the outlet before cleaning.  
A soft damp cloth may be used to clean the surface of the water cooler. When necessary,  
a mild detergent may be used. DO NOT use erosive chemical solvents to clean the unit,  
as this may damage the surface of the water cooler.  
DO NOT pour water on the exterior of the unit to avoid getting the internal electrical  
system damp. DO NOT immerse the unit in water when cleaning.  
The water bottle cap, hose, and drip tray may be washed in a dishwasher.  
Keep the water cooler 6 inches (15cm) away from the wall so it can work properly. Make  
certain all ventilation openings are clear of obstruction.  
Do not damage the heating or cooling system, paying particular attention to the black  
condenser or heat radiator on the back of the water cooler.  
If you will not use the water cooler for a long period of time, please unplug the power  
cord and drain the water cooler. Drain the water from all faucets, then remove the drain  
cap on back and allow it to drain. Make certain the drain cap is fastened tightly when  
finished.  
SPECIFICATIONS  
Model  
MW-59  
Power Supply  
115V, 60Hz  
6.3A  
Electrical Rating  
Refrigerant and Quantity  
Design Pressure (High Side)  
Design Pressure (Low Side)  
Dimensions  
R134a, 37g  
188psig  
88psig  
17.8"W x 13.9"D x 41.3" H  
 
TROUBLESHOOTING  
Please check the troubleshooting chart below. It includes several common problems, which you  
can correct at home, making a customer service call unnecessary.  
Problem  
Possible Cause  
Remedy  
Plug the power cord into an  
outlet.  
Unit is unplugged.  
Unit does not dispense  
hot and cold water.  
Main power supply is off.  
Reestablish main power supply.  
The hose cap is not attached  
properly to the connector on  
the water cooler.  
Connect properly. There will be  
a give when the hose cap slides  
properly over the connector.  
The cold water thermostat is  
set at too high a temperature.  
Over consumption of cold  
water in a short time.  
Adjust the thermostat.  
Wait a moment for the water to  
cool.  
Unit does not dispense  
cold water.  
The ventilation around the unit Space the unit from the wall by  
is insufficient.  
more than 15 cm.  
The temperature of water in  
the water bottle is too high.  
Place the water bottle in a cool  
(When the bottle is exposed to location out of direct sunlight.  
direct sunlight for a long time.)  
Unit does not dispense Over consumption of hot water Wait a moment for the water to  
hot water.  
in a short time.  
heat.  
Place the unit on a level, flat  
surface.  
Move the unit away from other  
objects.  
The appliance is not level.  
Unit is noisy during  
operation.  
Unit is touching other objects.  
The top portion of the faucet  
has become loose.  
Tighten the top threaded portion  
of the faucet.  
Call the customer service  
The faucet has been damaged. telephone number to repair the  
faucet.  
Water leaks from the  
faucet.  
The bottle may have small  
Replace with a new water bottle.  
pinholes.  
Tighten the drain cap. If the  
Water is dripping out  
of the water cooler and  
onto the floor.  
The drain cap on the back is  
not fastened properly.  
sealing silicon material inside  
the drain cap is torn or damaged,  
then replace with a new one.  
 
WARRANTY  
One Year Limited Warranty  
Soleus International Inc. warrants the accompanying Soleus Air MW-59 to be free of defects in  
material and workmanship for the applications specified in its operation instruction for a period  
of ONE (1) year from the date of original retail purchase in the United States.  
If the unit exhibits a defect in normal use, Soleus International Inc. will, at its option, either  
repair or replace it, free of charge within a reasonable time after the unit is returned during the  
warranty period.  
As a condition to any warranty service obligation, the consumer must present this Warranty  
Certificate along with a copy of the original purchase invoice.  
THIS WARRANTY DOES NOT COVER:  
1) Damage, accidental or otherwise, to the unit while in the possession of a consumer not  
caused by a defect in material or workmanship.  
2) Damage caused by consumer misuse, tampering, or failure to follow the care and special  
handling provisions in the instructions.  
3) Damage to the finish of the case, or other appearance parts caused by wear.  
4) Damage caused by repairs or alterations of the unit by anyone other than those authorized  
by Soleus International Inc.  
5) Freight and Insurance cost for the warranty service.  
ALL WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANT  
ABILITY ARE LIMITED TO ONE-YEAR DURATION OF THIS EXPRESS LIMITED  
WARRANTY. SOLEUS INTERNATIONAL INC. DISCLAIMS ANY LIABILITY FOR  
CONSEQUENTIAL OR INCIDENTAL DAMAGES AND IN NO EVENT SHALL SOLEUS  
INTERNATIONAL INC’S LIABILITY EXCEED THE RETAIL VALUE OF THE UNIT FOR  
BREACH OF ANY WRITTEN OR IMPLIED WARRANTY WITH RESPECT TO THIS  
UNIT.  
As some states do not allow the limitation or exclusion of incidental or consequential damages,  
or do not allow limitation on implied warranties, the above limitations and exclusions may not  
apply to you. This warranty gives you specific legal rights, and you may also have other rights  
that vary from state to state.  
For Warranty, Technical Support, Customer Service, Missing or Defective Parts  
Please Call (888) 876-5387  
Or Write To:  
Soleus International Inc.  
9451 Telstar Ave.  
El Monte, CA 91731 USA  
 

Sharp PDAs Smartphones IQ 8000 User Manual
Shure Home Theater System 27A8733A User Manual
Sony Ericsson Cell Phone 1160040 User Manual
Sony Power Supply AC E45HG User Manual
Sony Speaker A827 User Manual
Sony Stereo Receiver STR DE497 User Manual
Speco Technologies Security Camera CVC 627M User Manual
State Industries Water Heater 540A User Manual
Stiga Lawn Mower 8211 0072 80 User Manual
Sylvania TV VCR Combo RSEC313E User Manual