Sharper Image Refrigerator KP W140 User Manual

ONE YEAR LIMITED WARRANTY  
SI PRODUCTS sells its products with the intent that they are free of defects in manufacture and  
workmanship for a period of one year from the date of original purchase, except as noted below.  
SI PRODUCTS warrants that its products will be free of defects in material and workmanship under  
normal use and service. This warranty extends only to consumers and does not extend to Retailers.  
To obtain warranty service on your SI PRODUCTS product, mail the product and your dated sales receipt  
(as proof of purchase), postpaid, to the following address:  
Wine Preservation System  
SI PRODUCTS Consumer Relations  
Service Center Dept. 168  
3000 Pontiac Trail  
Commerce Township, MI 48390  
No COD's will be accepted.  
SI PRODUCTS does not authorize anyone, including, but not limited to, Retailers, the subsequent  
consumer purchaser of the product from a Retailer or remote purchasers, to obligate SI PRODUCTS in any  
way beyond the terms set forth herein. This warranty does not cover damage caused by misuse or abuse;  
accident; the attachment of any unauthorized accessory; alteration to the product; improper installation;  
unauthorized repairs or modifications; improper use of electrical/power supply; loss of power; dropped  
product; malfunction or damage of an operating part from failure to provide manufacturer’s recommended  
maintenance; transportation damage; theft; neglect; vandalism; or environmental conditions; loss of use  
during the period the product is at a repair facility or otherwise awaiting parts or repair; or any other  
conditions whatsoever that are beyond the control of SI PRODUCTS.  
SI Products  
Service Center  
1.888.856.6781  
8:30a.m. – 7:00p.m. (EST)  
M – F  
This warranty is effective only if the product is purchased and operated in the country in which the  
product is purchased. A product that requires modifications or adoption to enable it to operate in any  
other country than the country for which it was designed, manufactured, approved and/or authorized, or  
repair of products damaged by these modifications is not covered under this warranty.  
THE WARRANTY PROVIDED HEREIN SHALL BE THE SOLE AND EXCLUSIVE WARRANTY. THERE  
SHALL BE NO OTHER WARRANTIES EXPRESS OR IMPLIED INCLUDING ANY IMPLIED WARRANTY OF  
MERCHANTABILITY OR FITNESS OR ANY OTHER OBLIGATION ON THE PART OF THE COMPANY WITH  
RESPECT TO PRODUCTS COVERED BY THIS WARRANTY. SI PRODUCTS SHALL HAVE NO LIABILITY FOR  
ANY INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES. IN NO EVENT SHALL THIS WARRANTY  
REQUIRE MORE THAN THE REPAIR OR REPLACEMENT OF ANY PART OR PARTS WHICH ARE FOUND TO BE  
DEFECTIVE WITHIN THE EFFECTIVE PERIOD OF THE WARRANTY.  
Mail To: SI Products  
Consumer Relations  
Service Center Dept. 168  
3000 Pontiac Trail  
Commerce Township, MI  
48390  
e-mail:  
NO REFUNDS WILL BE GIVEN. IF REPLACEMENT PARTS FOR DEFECTIVE MATERIALS ARE NOT AVAILABLE,  
SI PRODUCTS RESERVES THE RIGHT TO MAKE PRODUCT SUBSTITUTIONS IN LIEU  
OF REPAIR OR REPLACEMENT.  
This warranty does not extend to the purchase of opened, used, repaired, repackaged and/or resealed  
products, including but not limited to sale of such products on Internet auction sites and/or sales of such  
products by surplus or bulk resellers. Any and all warranties or guarantees shall immediately cease and  
terminate as to any products or parts thereof which are repaired, replaced, altered, or modified, without  
the prior express and written consent of SI PRODUCTS.  
This warranty provides you with specific legal rights. You may have additional rights which may vary from  
state to state. Because of individual regulations, some of the above limitations and exclusions may not  
apply to you. For more information regarding our product line in the USA,  
Instruction Manual  
and Warranty Information  
KP-W140  
THE SHARPER IMAGE ® name and logo are registered trademarks.  
Marketed and distributed by SI Products under license. ©The Sharper Image.  
All rights reserved.  
IB-KPW140  
 
Fig. 1  
Wine Preservation System – Operation Instruction  
We recommend that you charge your Wine Preserver for at least 12 hours before  
using for the first time. Please follow the instructions for recharging as stated below:  
1) Charging your Wine Preserver  
Wine Preserver  
Plug end of the adaptor cord into the recharging base and the A/C end into an  
electrical outlet.  
Place the motorized wine preserver onto the charging base making sure that it is  
firmly in position and that it is in full contact with the recharging connection. (Fig.1)  
Press the power button once and a red light turns ON indicating that the unit is  
charging. It will take approximately 8-10 hours to recharge your Wine Preserver.  
When the wine preserver is fully charged, the LED light becomes green. (Fig.1)  
Power Button  
2) Date Dial  
Press and hold for 0.5 second on the screen of the LCD date counter to start  
the countdown.  
The LCD initially shows “0” with a single increment every 24 hours.  
It will automatically change to the 1st day after 24 hours and change to the 2nd  
day after 48 hours and so on, up until the 9th day.  
Press and hold for 0.5 second on the screen of the LCD date counter to turn off.  
Note: A 3V button cell battery comes pre-installed into the Date Dial. We  
recommended that you always keep the date dial off while not in use for  
energy saving.  
CHARGE  
Battery Replacement  
LED Light  
Charging Base  
Unscrew the four screws from its end cap to remove its top cover as  
shown attached.  
Take out the date counter module by releasing the snaps and replace  
the battery.  
Use a single CR927 3V type battery per module only.  
Date Dial  
AC Adaptor  
Silicon Stopper (4)  
Screws (4)  
5
4
 
3) Sealing the Wine Bottle  
Fig. 2  
MAINTENANCE  
Insert the stopper into the mouth of the  
bottle, pushing down until it fits firmly.  
Position the wine preserver over the  
wine bottle and stopper and push  
down gently. (Fig. 2)  
To Store  
You may leave the unit on display or you can store it in its box in a cool, dry place.  
To Clean  
Use only a soft dry cloth to clean the enclosure of the unit. NEVER use liquids or  
abrasive cleaner to clean.  
Press the power button, the battery-  
operated wine preserver automatically  
removes the air and the blue back  
light illuminates to indicate the unit is  
powered on. (Fig.2)  
When the seal is completed, the wine  
preserver will automatically shut off.  
Remove the wine preserver from  
the bottle. Press the date dial for  
0.5 second; it will automatically count  
and change from the 0 day to the  
9th day for each 24 hours.  
Press and hold the date dial to turn off.  
NOTE: Always return the wine  
preserver to the charging base when  
done. This will protect and charge the  
unit while not in use.  
6
7
 

Sharper Image Dehumidifier IB EVHD10 User Manual
Silvercrest Iron SDRB 1000 A16 User Manual
Singer Sewing Machine 99K28 User Manual
Soleus Air Air Conditioner PE8 12R 32 User Manual
Sony Flat Panel Television 3 297 694 161 User Manual
Sony Laptop PCG 505TR User Manual
Star Micronics Printer TSP600 SERIES User Manual
Sterling Plumbing Product BP1012 User Manual
Subaru Automobile Parts EX40 User Manual
Tanita Scale BF 662W User Manual