Metra Electronics Computer Drive 99 8206 User Manual

INSTALLATION INSTRUCTIONS FOR PART 99-8206  
APPLICATIONS  
Toyota Highlander 2001-2007  
4-Runner (Excluding Limited) 2003-2008  
99-8206  
KIT FEATURES  
• DIN Head Unit Provision with Pocket  
• ISO DIN Head Unit Provision with Pocket  
KIT COMPONENTS  
A) Radio Housing • B) ISO Brackets • C) ISO Trim Plate • D) Highlander Brackets • E) 4-Runner Brackets  
B
A
E
WIRING AND ANTENNA CONNECTIONS (Sold Separately)  
Harness:  
C
• 70-1761 - Toyota harness 1987-up  
• TYTO-01 - Toyota amp interface harness 2003-up  
Antenna Adapter:  
D
• Not required  
TOOLS REQUIRED:  
Phillips Screwdriver • Socket Wrench • Cutting Tool  
1-800-221-0932  
© COPYRIGHT 2004-2009 METRA ELECTRONICS CORPORATION  
 
DASH DISASSEMBLY  
99-8206  
TOYOTA 4 RUNNER 2003-2008  
(EXCLUDING LIMITED)  
A
1
Disconnect the negative battery ter-  
minal to prevent an accidental short  
circuit.  
Unsnap and remove trim from around  
shifter.  
2
3
Unsnap and remove trim covers from  
around center console pocket edge  
at front and rear of console.  
B
4
5
6
Unsnap and remove center console  
cover. (Figure A)  
Unsnap trim ring from around ignition  
key cylinder.  
Remove (1) 10 mm bolt from bottom  
right of panel below steering column.  
Unsnap panel and pull away to gain  
access behind panel. (Figure B)  
C
7
8
Remove (1) 10 mm bolt on bottom  
left of center panel behind panel  
below steering column. (Figure B)  
Remove (1) 10 mm bolt beneath cli-  
mate control behind pocket door.  
Unsnap and remove climate control.  
(Figure C)  
9
Remove (2) 10 mm bolts beneath  
radio behind climate controls.  
D
10  
11  
Unsnap and remove entire center  
panel around radio. (Figure D)  
Remove (2) 10 mm bolts securing  
radio to remove.  
1
 
DASH DISASSEMBLY  
99-8206  
TOYOTA HIGHLANDER 2001-2007  
A
Disconnect the negative battery  
terminal to prevent an accidental  
short circuit.  
1
Pull and remove dash panel from  
radio and climate controls. Tip: There  
are 8 clips. (Figure A)  
2
3
Remove (6) 10mm bolts from radio  
and climate controls assembly.  
(Figure B)  
B
Remove assembly and disconnect  
the wiring.  
4
5
Remove (8) Phillips bolts and (4) Phillips  
screws to separate brackets from assem-  
bly. (Figure C)  
C
2
 
KIT DISASSEMBLY  
99-8206  
4 RUNNER BRACKET ASSEMBLY  
TOYOTA HIGHLANDER BRACKET ASSEMBLY  
A
Snap the appropriately marked Mounting  
Brackets for your application onto the  
sides of the Radio Housing. The brackets  
are marked 4-Runner or Highlander and  
left or right. (Figure A - 4 RUNNER)  
(Figure B - HIGHLANDER)  
1
B
3
 
KIT ASSEMBLY  
99-8206  
DIN HEAD UNIT PROVISION WITH POCKET  
A
Slide the DIN cage into the Radio  
Housing and secure by bending the  
metal locking tabs outward. (Figure A)  
1
2
Snap the aftermarket radio into the  
cage and secure. (Figure B)  
B
4
 
KIT ASSEMBLY  
ISO DIN HEAD UNIT PROVISION  
99-8206  
A
Mount the ISO Brackets to the head  
unit with the screws supplied with  
the radio. (Figure A)  
1
Snap the radio into the radio housing  
until the side clips engage. (Figure B)  
2
3
Snap the ISO Trim Plate onto the  
Radio/Housing assembly. (Figure B)  
B
5
 
FINAL ASSEMBLY  
99-8206  
FINAL ASSEMBLY  
A
B
A)  
B)  
C)  
D)  
Strip wire ends back 1/2"  
Twist ends together  
Solder  
Tape  
C
D
Locate the factory wiring harness in the dash. Metra recommends using the  
proper mating adapter and making connections as shown.  
(Isolate and individually tape off the ends of any unused wires to prevent  
electrical short circuit.)  
1
Re-connect the negative battery terminal and test the unit for proper operation.  
Reassemble radio and dash assemblies in reverse order of disassembly.  
2
3
FINAL WIRING CONNECTIONS  
Make wiring connections using the EIA color code chart shown below and the instructions included with the head  
unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and individually  
tape off ends of any unused wires to prevent electrical short circuit.  
METRA / EIA WIRING CODE  
12V Ignition / Acc . . . Red  
Dimmer . . . . . . . . . . Orange / White  
12V Batt / Memory . . Yellow  
Right Front (+) . . . . . White  
Ground . . . . . . . . . . . Black*  
Left Front (-). . . . . . . White / Black  
Power Antenna . . . . . Blue  
Right Rear (+). . . . . . Violet  
Amp Turn-On . . . . . . Blue / White  
Right Rear (-) . . . . . . Violet / Black  
Amp Ground . . . . . . . Black / White  
Left Rear (+). . . . . . . Green  
Illumination. . . . . . . . Orange  
*NOTE: When Black a wire is not present, ground radio to vehicle chassis.  
All colors may not be present on all leads due to manufacturer’s specifications.  
1-800-221-0932  
REV. 07/01/09 © COPYRIGHT 2004-2009 METRA ELECTRONICS CORPORATIO INST99-8206  
 

Learning Resources Baby Toy LER 9301 User Manual
Lexmark All in One Printer 5021 0XX User Manual
Lexmark MP3 Player GEX XMP3 User Manual
Life Fitness Treadmill 9100 Series User Manual
Lincoln Electric Welding System IM727 User Manual
LST Smoke Alarm SIM016 3 User Manual
Mabe Canada Refrigerator GWS04 User Manual
Margaritaville Gas Grill NBMGLG1000 User Manual
Maxtor Computer Drive Pocket Drive User Manual
Memorex MP3 Player MPD8300 User Manual